Duda Ventilador Grafica
-
I HAVE AN ASUS GTS250 1G DDR3 V2 WW
THE PROBLEM IS the fan. I'll explain: If I set the fan to work at more than 45% by adjusting the manual configuration (the minimum is 36% and the maximum is 99%) after about 5, 10 minutes it stops, (regardless of whether I subject it to a stress test or not) while if I leave it at the minimum (36%) in manual configuration, the fan stays on, even when subjected to the furmark or 3dmark test (logically it reaches higher levels (around 74 degrees maximum) because the fan moves less air than at 100%) Isn't that very strange?
EDIT: I CAN'T set the automatic fan configuration, because when I subject it to a test the fan goes to full and after 10 minutes the fan stops and logically I have to stop the test, and restart the PC for the fan to work again. (by disconnecting the power when restarting) I'll leave you a video
take a look from minute 3:30. The noise you hear is the fan, and from 3:30 it stops.
It's super strange, I hope for help.
-
What components do you have and with what program do you change the fan speed?
-
what components do you have and with what program do you change the fan speed?
Hello, 500w power supply. quad core q6600 asus P5G41-M LE motherboard., dvd combo and sata II hard drive
THE SOFTWARE TO MODIFY THE FAN SPEED IS SMART DOCTOR THAT CAME WITH THE ASUS GRAPHICS
I JUST PLAYED 10 MINUTES OF BATTELEFIELD 3 AND IT HAS CRASHED, STOPPING THE FAN..
I AM DESPERATE
-
"500w power supply" doesn't say much about it. brand and model of that power supply? because a generic power supply can cause many problems. anyway, uninstall smart doctor and download "msi afterburner", it gives better results.
-
Greetings.
I have the same cooler but from manufacturer GIGABYTE and its fan broke so I replaced it with an artic cooling twin turbo and under idle it went down to 35 and under full load it didn't go over 60 so if you can't find a way to fix the stock fan the artic cooling would be a good option. -
"500w source" doesn't say much about it. brand and model of that source? because a generic source can give many problems. anyway uninstall the smart doctor and download the "msi afterburner", gives better results.
It's a 500 pc case. Of the bad ones I suppose. But I have a doubt. the fan turns on when it feels like it. But if I remove the 6 pin connector, the fan starts at full. But you can't see the screen. Also I say that the 6 pin is connected to a molex adapter, not directly to the source.? What solutions do I have? Me handicho that it can be the heat sensor, and that sounds expensive and very bad
-
I think you have the vent broken, try plugging one in that you have at home to test it
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Registrarse Conectarse