Does G27 damage the table with the anchors?

[tremen]

Hello,
Until I make the cockpit.. I'm going to anchor my G27 on the table.. which I received today, by the way.

The doubt I have is whether those anchors mark the table or damage it.. it's a new table and it's white.. and I wouldn't want to leave any kind of mark.. or scratches.. when the force feedback acts.. and I do trackings.. can it'mess up' my table?

thanks

[Clipper]

@tremen:

Hello,
Until I make the cockpit.. I'm going to anchor my G27 on the table.. which by the way I receive today.

The doubt I have, is if those anchors mark the table or damage it.. it's a new table and it's white.. and I wouldn't want to leave any kind of mark.. or scratches.. when the force feedback acts.. and does trackings.. can it'mess up' my table?

thanks

you can make some "silen bloks " with a piece of bike camera or similar
if not a couple of foam or wood blocks
regards

[whoololon]

I have been looking closely at that clamping system, and the fact that it is made of plastic means that, a priori, it will not damage a melamine laminate or a polyurethane coating.
However, it may break due to excessive tightening because when used on smooth surfaces it tends to slip.

I think Clipper's suggestion (the bike camera or any other rubbery material) is very accurate. :sisi:

[tremen]

thank you very much to both of you.. I will look for some kind of "silent block" hehe..

until I build my cockpit..

regards!