Doubt about problem in HD6970

[airsoftlocura]

Good afternoon, first of all, I introduce myself, my name is sacha and I wanted to ask you a couple of questions after googling and only finding on igles…

If I have not placed the post in the right place, I apologize.

I have the following PC

Asus p9X79 Deluxe
16gb ddr 3 2133 gskill
Intel i7 3930k
Shapire Radeon HD 6970 2gb
FA 1100w
SSD OCZ 128 Gb
Segate 500gb sata
Maxtor 200 sata
Maxtor 160 sata

Until 2 days ago, the PC was working wonderfully, as it was already a bit saturated, I decided to format it.

When I formatted and reinstalled Windows and all its drivers, when I entered the PC, only the SSD disk came up, the other 3 did not appear, the strange thing is that in the Intel application that comes for HDDs, they appeared to me but these were not present in my PC.

I dismantled the whole PC to clean all the dust accumulated from a whole year,

Once cleaned, I put everything back together, when I turned it on, it only recognized the SSD disk, the BIOS did not recognize any SATA device, including the reader.

I unplugged all the connectors and changed the SATA locations, alternating their order and reconnected, suddenly it made the attempt to start but then it turned off.

I pressed the motherboard's power button but it did not turn on, I did a CMOS reset and it started again but now 3 red LEDs light up on the motherboard

The first one to light up is the one on the RAM, it flashes and turns off,
Followed by an LED above the VGA that says VGA LED and finally one in the lower corner of the motherboard that says I think boot device and stays on and does not open video, and nothing is seen on the screen, the LED indicator tells me A2 or A0, I looked in the manual and searched on the internet but only appears something on tomshardware and through the translator I do not understand.

I grabbed and changed the VGA for one that I had around for 30€ and now it does open video but it does not recognize any SATA device, no matter where I put it in any of the 8, it does not recognize any of them

I reconnect the 6970 in another PC and it does not open video either,

Could it be that this VGA has died??

On the other hand, how do I solve the problem of the SATA devices so that it recognizes the HDDs.

Thank you very much and I hope for your responses as I am really screwed without a PC,

Many thanks

[Franziskaner]

hello and welcome
i think you should go step by step, first the graphics card and then the rest.
disconnect all peripherals, clean the memory slots and the PCI of the graphics with a brush or compressed air, connect only one memory module and the graphics and see if the PC starts.
anyway if you say that you have tried the graphics card on another PC and it does not work... it looks bad.
P.D. try to take care of the spelling a little ;D it is very possible that many people will not want to answer you because they will consider that if you do not bother to write reasonably well, you will not bother with anything
greetings

[airsoftlocura]

Thank you very much for the advice. I'm writing from my mobile and my fingers are quite big xD

A single memory module, the 6970, and it doesn't open video,
but if I put a geoferce from 4 years ago, it lets me enter the bios.

I've plugged the 6970 into a
P5q
6600 core duo
8gg gskill

And it still doesn't open video, which is what's bugging me.

2 points. The motherboard

With the geoferce, it lets me enter the bios, but why doesn't it recognize any sata ports??
In the sata section, I see 6 ports but
No hard drives and all are connected.

I doubt it's the power supply, but the fans are working, which means there's power in the molexes.

Greetings and thanks!

[gamingpy]

Apparently as you say it's a problem with your graphics card and your sata or siemplemente connectors or simply it's not getting enough power and therefore it doesn't recognize them. It would be better if you uploaded a video recorded from a mobile or something to see more clearly the problem you have since as you explain it's a bit more difficult to see the problem clearly.

[xinyongka]

¡Esta publicación está eliminada!

[Franziskaner]

hello.
reset the bios or set it to default values.
check the power connectors of the graphics card and if you can try with another power supply
regards

[fjavi]

@airsoftlocura:

Buenas tardes, ante todo me presento me llamo sacha y os queria preguntar un par de dudas despues de googlear y solo encontrar en igles…

Si no e colocado el post en el sitio adecuado pido perdon.

Tengo el siguiente Pc

Asus p9X79 Deluxe
16gb ddr 3 2133 gskill
Intel i7 3930k
Shapire Radeon HD 6970 2gb
FA 1100w
SSD OCZ 128 Gb
Segate 500gb sata
Maxtor 200 sata
Maxtor 160 sata

Hasta hace 2 dias el pc iba de maravilla, como ya antadaba un poco saturado decidi formatearlo.

Al formatear y volver a instalar windows y todos sus drivers, el entrar en el pc solo salia el disco Ssd, los otros 3 no aparecian, lo extraño esque en la aplicacion de intel que trae para hdd me aparecian pero estos no estaban presentes en mi pc.

Destripe todo el pc para limpiar todo el polvo acumulado de 1 año entero,

Una vez limpio lo volvi a montarlo todo, cuando lo encendi ya solo me reconocia el disco ssd nada mas, la bios no reconocia ningun dispositivo sata incluido el lector.

Desenchufo todos los conectores y cambio de ubicacion los sata alternado su orden y vuelvo a conectar, derrepente hace el amago de arrancar pero de apaga.

Le doy al boton de la placa de encendido pero no enciende, ago un clear Cmos y vuelve a arrancar perp ahora se encienden 3 leds rojos en la placa

El primero en encenderse es el de lad memos parpadea y se apaga,
Acto segido se enciende un led encima de la Vga que pone Vga led y por ultimo se enciende uno en la esquina inferior de la placa que pone creo boot device y se queda fijo y no abre video, y no se ve nada pantalla en negro el indicador led me indica A2 o A0 e mirado en el manual y e buscado en internet pero solo aparece algo en tomshardwere y por el traductor no me entero.

E cogigo y e cambiado la Vga por una que tenia por ai de 30€ y ahora si habre video pero no me reconoce ningun dispositivo sata da igual que lo ponga en cualquiera de los 8 no reconoce en ninguno de ellos

Vuelvo a conectar la 6970 en otro pc y esta no abre video tampoco,

Puede ser que esta vga aya muerto??

Por otro lado como resuelvo el problrma de los satas para que me reconozca los hdd.

Muchas gracias y espero vuestras respuestas ya que estoy to jodido sin pc,

Muchas grcias

Yo el Intel rapid storage lo desinstalaría y no lo volveria a instalar, a mi me ocurrio algo parecido al instalarlo en una x58 desaparecían los discos.

por eso se quedara buscando discos con la pantalla en negro y una raya pequeña parpadeando, desinstálalo y si tienes un punto de restauración seria bueno volver antes de instalarlo.

De todas formas debería funcionar la tarjeta en la P5Q, es raro que no funcione en ninguna de las dos placas.

saludos