A multitude of problems!!! Help please!!!

[Mystique]

If you notice that the case gives you a current, something is wrong.

Mount the minimum (motherboard + graphics card + disk + power supply) on top of a wooden table to rule out any contact with the case, which you do not specify what it is.

Check that the temperatures are within the "normal" range, that it is not shutting down for safety when it reaches high temperatures.

Out of curiosity, does the outlet where the computer is connected have a ground connection? Sometimes not having it makes you notice that tingling sensation. Having an outlet with the possibility of having a ground connection does not mean it is connected... if you could see the mess that is made...

[Witizer]

Hello, thanks to everyone for the replies.

I have replaced the power cables of the monitor and the tower, and I have not noticed the casing being under tension again.

The computer hangs less, but it still does.

Here you can see the temperatures. The graphics card, which always goes above 60ºC, is a Gigabyte 9600GT that does not have a fan but a heatsink (it came like that from the factory).

I did not comment on the tower because it is generic.

Is it possible that the processor could be failing or is that very rare?

How could I be sure that the motherboard is what is failing? Everything points to a motherboard failure, but it seems a bit strange that I could start the computer and work for a while under Windows 7, perhaps if it were a motherboard failure, I could not start the computer. Any similar experiences?

Thank you very much!!

[Witizer]

Another thing I have noticed is that my clock is often 1 hour behind under Windows 7. The time zone is correctly set. It could be the BIOS battery, but do you think the BIOS battery could be causing all of this?

[incrediboy]

those temperatures seem high to me, does the case have proper ventilation?

[krampak]

At -64ºC I think it's quite cool, I stayed at -50ºC with the Mach II so you can't complain I think the CPU sensor doesn't pick it up well..

[Witizer]

The same thing keeps happening to me…. :( any ideas?

[CNCBCN]

@krampak:

At -64ºC I find them quite cool, with the Mach II I stayed at -50ºC so you can't complain I think the CPU sensor doesn't pick it up well..

I had something similar happen to me (only in reverse) or rather it still happens, the PC Probe II shows 71 degrees on the CPU at rest, while Core Temp shows 31 I don't know what the problem is but... as it doesn't crash with 4 CPU brun nothing happens

Another thing I've noticed is that my clock is often an hour late, under Windows 7. The time zone is correctly configured. Maybe it's the BIOS battery, but do you think the BIOS battery could be causing all this?

check the time in the BIOS if it's correct it's not the battery

you could disassemble the PC and put it on a newspaper or something like that and press F.A (to see if it's the power supply)
and for now I can't think of anything else

[Sylver]

The time thing could be a BIOS battery issue, but so many failures together make it look like the motherboard is dying...

It could be that the disk controller is broken, that happened to me once.

Did you do what Mystique recommended, to only put in the minimum to see how it reacts? Start there...

Regards

[nikera]

I think it's the bios because it looks like it also shows the error message that the bios does not start

[CNCBCN]

nikera you have a PM

[jordiqui]

@Mystique:

If you notice that the case gives you a current, something is wrong.

Mount the minimum (motherboard + graphics card + disk + power supply) on top of a wooden table to rule out any contact with the case, which you don't say what it is.

Check that the temperatures are within the "normal" range, that it's not shutting down for safety when it reaches high temperatures.

Out of curiosity, does the outlet where the computer is connected have a ground connection? Sometimes not having it makes you notice that tingling. That you have an outlet with the possibility of having it doesn't mean it's connected... if you could see the mess that's made...

At my partner's house when I touch the faucet and the dishwasher, I act as a ground. And zap. There's something there. What to rule out to start, the ground should always be there so that the current doesn't do its thing. But those CPU temperatures I'd like to see less than 65. In any case, first, as mystique says, rule out leaks because it's the beginning of the end of the chips, circuits, etc.