Help with PC starts and nothing is seen

[sirvionte]

Good morning.
I'll tell you about my problem that I don't know where it comes from.
My equipment.
Tower.. nzxt tempest
Micro… i5 2500k
Motherboard... asrock p67 extreme 4
Memory... 2x4 gb g.skilk cl9
Cooler master water
Power supply.... fatality modular 550w
Graphics card...gigabyte gtx 560 soc
With all these components it has been more or less 2 years until a few weeks ago I changed the graphics card for the msi gtx760 everything was fine I thought the power supply wasn't going to work and everything was fine I had been playing for more or less 2 weeks in battefield 4 and world of tanks in windows 8.1 I installed some new gforce drivers the last ones and yesterday while playing world of tanks the pc turned off suddenly like a light switch and now it starts everything except the video, I have tried the gtx 560 and nothing the strange thing is that the motherboard has a little screen dr.debug and it doesn't turn on it doesn't do anything all the fans connected to the motherboard work, I have removed the memory I have tried only 1 in different sockets and nothing, I have disconnected everything from the power supply except the motherboard and graphics card and nothing, could it be the motherboard? I had an auto overclock of 4.2 mhz with maximum temperatures playing at full over 50°.
Regards

Sent from my LG-E975 using Tapatalk

[Fassou]

A Clear CMOS, and leave it with only one slot until it boots up.

Salu2!

[sirvionte]

@sirvionte:

Good morning.
I'll tell you about my problem that I don't know where it comes from.
My equipment.
Tower.. nzxt tempest
Micro… i5 2500k
Motherboard... asrock p67 extreme 4
Memory... 2x4 gb g.skilk cl9
Cooler master water
Power supply.... fatality modular 550w
Graphics card...gigabyte gtx 560 soc
With all these components it has been more or less 2 years until a few weeks ago I changed the graphics card for the msi gtx760 everything was fine I thought the power supply wasn't going to last and everything was fine I had been for more or less 2 weeks playing battlefield 4 and world of tanks on windows 8.1 I installed some new gforce drivers the last ones and yesterday playing world of tanks the pc turned off suddenly like a light switch and now it starts everything except the video, I have tried the gtx 560 and nothing the strange thing is that the motherboard has a small dr.debug screen and it doesn't turn on it doesn't do anything all the fans connected to the motherboard work, I have removed the memory I have tried only 1 in different sockets and nothing, I have disconnected everything from the power supply except the motherboard and video card and nothing, could it be the motherboard? I had an auto overclock of 4.2 mhz with maximum temperatures playing at full over 50°.
Another thing I noticed with the game world of tanks is that with the application Hwnfo64 that gives you all the information of the pc temp, speed processors etc.. very complex the processors as a maximum value it puts to 5.4 mhz and the gpu also goes up a bit I don't know if it's a failure of the application since with battlefield 4 it didn't happen maximum 4220 mhz.
Regards

Sent from my LG-E975 using Tapatalk

Sent from my LG-E975 using Tapatalk

[sirvionte]

Sorry how is that done I saw that there is a 3-pin connector and a bumper set in 1 and 2 and it says clear cmos 2 and 3 what do I do connect 2 and 3 or how is it done I have never done it before

Sent from my LG-E975 using Tapatalk

[Fassou]

That's why the boards come with a manual with all these instructions :facepalm:

The idea is to put the Jumper in the Clear-CMOS position (you say it's 2-3 on your board) for a couple of minutes, and then turn off the power supply for another 2-3 minutes before putting the Jumper back in its normal position and starting the computer.

If there are no damaged components, it should start up and indicate that the CMOS information is erased or damaged, forcing you to enter the BIOS.

Salu2!

[sirvionte]

Ok when I get it I will try it and tell you, thanks for replying so quickly, I'll tell you later.

Sent from my LG-E975 using Tapatalk

[sirvionte]

I have tried the bumper on pin 2 and 3 which says clear cmos and now the pc does not start if I put it on 1 and 2 yes and if I do not put it on any either. Behind the tower I have a button that also says clear cmos but I do not know how to use it if with the bumper on or without it.

Sent from my LG-E975 using Tapatalk

[Fassou]

@Fassou:

The idea is to put the Jumper in the Clear-CMOS position (you say it's 2-3 on your board) for a couple of minutes, and then turn off the power supply for another 2-3 minutes and then put the Jumper back in its normal position and start the computer.

[sirvionte]

But I put it in position 2 and 3 with the PC turned off, I say this because if I put it there, nothing starts up.

Sent from my LG-E975 using Tapatalk

[Fassou]

@Fassou:

The idea is to put the Jumper in the Clear-CMOS position (you say it's 2-3 on your board) for a couple of minutes, and then turn off the power supply for another 2-3 minutes before putting the Jumper back in its normal position (it will be 1-2 on your board) and start the computer.

[sirvionte]

I don't understand why you answer me the same thing when I figure out the first thing that I'm not clear about if I put 2 and 3 clear cmos and restart the pc and leave it for 2 or 3 minutes then I turn off the power cable included another 2 or 3 min and then bumper 1 and 2 which says normal and wait for the bios to enter no, but as I told you before it doesn't start anything with the bumper on 2 and 3 so I don't know how I left it like that for 2 or 3 min if it doesn't start.

Sent from my LG-E975 using Tapatalk

[Fassou]

The jumper on 2-3 is done with the PC turned off, and you don't turn it on until after you put it back in its normal position.

Salu2!

[sirvionte]

Nothing throws it that way and nothing follows the screen without signal, tomorrow I will take it to appinformatica to see what it could be, it smells to me that it is the memories but it seems strange to me that none of the 2 work.

Sent from my LG-E975 using Tapatalk

[sirvionte]

In the end it was the power supply they left me one I tried it and it was that so I bought a cooler master g700 of 700w and it works.
Thanks for your help.

Sent from my LG-E975 using Tapatalk