Opinions

[Sylver]

He says that on the 1Tb disk you are going to put, you partition it into a 200Gb part and another with the rest of the size, so that when you buy the 256Gb SSD, you can clone the entire partition of the disk and it will fit perfectly on the SSD, so you have your system intact, just as you had it on the partition, but on a disk a lot of times faster :sisi:

Greetings

[Vegeta SM]

A question about the processor voltage, I was led to look at it and it shows 1.044 V. more or less, is this the correct voltage?

[Sylver]

What does google say about it? Because I don't have that micro or the box, I don't know it by heart...

Regards

[Vegeta SM]

I can't find anything on Google or maybe I'm not searching well jajaja

[Vegeta SM]

I've been looking at the bios and entering this that says CPU Core Voltage Control and I get these options with these voltages set and everything set to auto:

CPU VRIN Voltage 1.800 V. –------ Auto.

CPU VCore 1.034 V. ----------- Auto.

CPU Graphics (VAXG) 1.000 V. --------- Auto.

CPU RING Voltage 1.050 V. ----------- Auto.

I set it just as it appears in the Bios.

And about the processor voltage, I don't see anything.

[Sylver]

I think it is totally correct, because in CPU Vcore you have 1.034 V as the "estimated" value by the BIOS, and as long as it is on auto it will keep it around that value as needed. If you then measure it from the system and it is close to that value (either slightly above or slightly below) there is no problem.

Regards

[Obione]

Sylver and almost everyone else knew it was okay. We know because we've looked at Intel specs before and we've Googled it.

Google it :ugly:

[Vegeta SM]

so is everything correct?

[Sylver]

Greetings

[Vegeta SM]

one last question, I don't know if it's broken or if it's like this and it's something I've been suffering from since my old PC and it's with my DVD recorder, when it starts reading what is installing or something like that the PC slows down a lot until sometimes it gets stuck and takes time to respond, any suggestions?

[Sylver]

Try another drive to rule out, it's probably been damaged for a while, although a slight delay is not uncommon either. The efficiency with which drives access information from CDs and DVDs is not the same as what we experience with USB devices. However, if it becomes a clearly abnormal lag, change the drive directly, as it is probably already in its last days of life.

Regards