Help problem with Asus P8P67 LE motherboard

marquezzzzz

I think I've found the problem.

It may be due to the pins on the motherboard as I've been looking at the processor from the contact side and on most there is a dot in the middle of the pins on the board but there are a few where the pin mark is almost outside the processor contact.

How can a board come with the pins wrong? because it's impossible that I bent them when I put the micro in as it only has one correct position. Could this be why my PC won't boot?

Sylver

Try to mount the board with the micro only (heatsink also obviously)
Without memory and without graphics, just board + micro.

There it should already beep something…

Regarding the pins that you just commented... there have been cases of boards that have arrived from the store with bent/broken pins, they can be corrected manually if they are not broken, but it is best to contact the store so that they take action.

Greetings

CNCBCN

10
RMA strips and point that like straightening a pin you blow it up then you eat the board with potatoes and no salt :nono::nono:
and if it can be because of that the pc didn't start up

Sylver

@CNCBCN:

10
RMA strips and point that like straightening a pin you screw it up then you eat the board with potatoes and no salt :nono::nono:
and if it can be because of that the pc didn't start up

Indeed that's what it is, the only danger is that the same thing happens to him as to Rules when he tried to pull an RMA with the ASRock… :vayatela:

CNCBCN